gg修改器绑定游戏_gg游戏修改器

作者：佚名来源：网友日期:2025-02-23 01:35:40

GG修改器破解版下载地址：https://ghb2023zs.bj.bcebos.com/gg/xgq/ggxgq?GGXGQ

大家好，今天小编为大家分享关于gg修改器绑定游戏_gg游戏修改器的内容，赶快来一起来看看吧。

一、准备环境
VMware软件、Centos7虚拟机

二、添加网卡
为虚拟机再添加两块网卡，查看网卡信息，可以看到有ens32、ens34、ens35三块网卡
ip addr

1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN group default qlen 1000 link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00 inet 127.0.0.1/8 scope host lo valid_lft forever preferred_lft forever inet6 ::1/128 scope host valid_lft forever preferred_lft forever 2: ens32: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast state UP group default qlen 1000 link/ether 00:0c:29:54:02:06 brd ff:ff:ff:ff:ff:ff inet 192.168.30.142/24 brd 192.168.30.255 scope global noprefixroute dynamic ens32 valid_lft 1615sec preferred_lft 1615sec inet6 fe80::d089:c15:e69a:8ce4/64 scope link noprefixroute valid_lft forever preferred_lft forever 3: ens34: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast state UP group default qlen 1000 link/ether 00:0c:29:54:02:1a brd ff:ff:ff:ff:ff:ff inet 192.168.30.143/24 brd 192.168.30.255 scope global noprefixroute dynamic ens34 valid_lft 1765sec preferred_lft 1765sec inet6 fe80::a4af:b843:9032:9dd3/64 scope link noprefixroute valid_lft forever preferred_lft forever 4: ens35: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast state UP group default qlen 1000 link/ether 00:0c:29:54:02:10 brd ff:ff:ff:ff:ff:ff inet 192.168.30.141/24 brd 192.168.30.255 scope global noprefixroute dynamic ens35 valid_lft 1765sec preferred_lft 1765sec inet6 fe80::b7cf:76d7:23aa:63c2/64 scope link noprefixroute valid_lft forever preferred_lft forever

查看网卡配置文件，可以看到添加网卡后，并没有生成对应的网卡文件
ls /etc/sysconfig/network-scripts/ifcfg*

/etc/sysconfig/network-scripts/ifcfg-ens32 /etc/sysconfig/network-scripts/ifcfg-lo

可以为网卡生成配置文件，但在本文中不需要这样做

nmcli connection add type ethernet con-name ens34 ifname ens34 autoconnect yes nmcli connection add type ethernet con-name ens35 ifname ens35 autoconnect yes

再次查看网卡配置文件，生成成功
ls /etc/sysconfig/network-scripts/ifcfg*

/etc/sysconfig/network-scripts/ifcfg-ens32 /etc/sysconfig/network-scripts/ifcfg-ens35 /etc/sysconfig/network-scripts/ifcfg-ens34 /etc/sysconfig/network-scripts/ifcfg-lo

三，选定网卡绑定模式
多网卡一共有7种bond模式，这里直接选用mode=6 (balance-alb) Adaptive load balancing（适配器适应性负载均衡），该模式不需要交换机支持

四、开始配置
1、加载bonding模块，并设置开机启动

[root@localhost ~]# lsmod | grep bonding [root@localhost ~]# modprobe bonding [root@localhost ~]# lsmod | grep bonding bonding 152979 0

启用rc.local开机启动项
chmod +x /etc/rc.d/rc.local
在文件中写入modprobe bonding

2、建立bond网口配置文件并进行配置
/etc/sysconfig/network-scripts/ifcfg-bond0

DEVICE=bond0 NAME=bond0 TYPE=Bond BONDING_MASTER=yes IPADDR=192.168.30.250 PREFIX=255.255.255.0 GATEWAY=192.168.30.2 DNS1=114.114.114.114 ONBOOT=yes BOOTPROTO=none BONDING_OPTS="mode=6 miimon=100"

3、修改三块网卡的配置
vi /etc/sysconfig/network-scripts/ifcfg-ens32

DEVICE=ens32 ONBOOT=yes BOOTPROTO=none TYPE=Ethernet MASTER=bond0 SLAVE=yes

vi /etc/sysconfig/network-scripts/ifcfg-ens34

DEVICE=ens34 ONBOOT=yes BOOTPROTO=none TYPE=Ethernet MASTER=bond0 SLAVE=yes

vi /etc/sysconfig/network-scripts/ifcfg-ens35

DEVICE=ens35 ONBOOT=yes BOOTPROTO=none TYPE=Ethernet MASTER=bond0 SLAVE=yes

4、重新加载网络配置
注意：这一步会断网！

nmcli connection reload && systemctl restart network.service

使用新IP链接ssh

五、验证绑定是否生效
cat /proc/net/bonding/bond0

Ethernet Channel Bonding Driver: v3.7.1 (April 27, 2011)


Bonding Mode: adaptive load balancing

Primary Slave: None

Currently Active Slave: ens32

MII Status: up

MII Polling Interval (ms): 100

Up Delay (ms): 0

Down Delay (ms): 0
Slave Interface: ens32

MII Status: up

Speed: 1000 Mbps

Duplex: full

Link Failure Count: 0

Permanent HW addr: 00:0c:29:54:02:06

Slave queue ID: 0
Slave Interface: ens34

MII Status: up

Speed: 1000 Mbps

Duplex: full

Link Failure Count: 0

Permanent HW addr: 00:0c:29:54:02:1a

Slave queue ID: 0

Slave Interface: ens35 MII Status: up Speed: 1000 Mbps Duplex: full Link Failure Count: 0 Permanent HW addr: 00:0c:29:54:02:10 Slave queue ID: 0

查看网卡状态
ip addr

1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN group default qlen 1000 link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00 inet 127.0.0.1/8 scope host lo valid_lft forever preferred_lft forever inet6 ::1/128 scope host valid_lft forever preferred_lft forever 2: ens32: <BROADCAST,MULTICAST,SLAVE,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast master bond0 state UP group default qlen 1000 link/ether 00:0c:29:54:02:06 brd ff:ff:ff:ff:ff:ff 3: ens34: <BROADCAST,MULTICAST,SLAVE,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast master bond0 state UP group default qlen 1000 link/ether 00:0c:29:54:02:1a brd ff:ff:ff:ff:ff:ff 4: ens35: <BROADCAST,MULTICAST,SLAVE,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast master bond0 state UP group default qlen 1000 link/ether 00:0c:29:54:02:10 brd ff:ff:ff:ff:ff:ff 5: bond0: <BROADCAST,MULTICAST,MASTER,UP,LOWER_UP> mtu 1500 qdisc noqueue state UP group default qlen 1000 link/ether 00:0c:29:54:02:06 brd ff:ff:ff:ff:ff:ff inet 192.168.30.250/24 brd 192.168.30.255 scope global bond0 valid_lft forever preferred_lft forever inet6 fe80::20c:29ff:fe54:206/64 scope link valid_lft forever preferred_lft forever

查看接口带宽，带宽为3G
ethtool bond0

Settings for bond0: Supported ports: [ ] Supported link modes: Not reported Supported pause frame use: No Supports auto-negotiation: No Supported FEC modes: Not reported Advertised link modes: Not reported Advertised pause frame use: No Advertised auto-negotiation: No Advertised FEC modes: Not reported Speed: 3000Mb/s Duplex: Full Port: Other PHYAD: 0 Transceiver: internal Auto-negotiation: off Link detected: yes

连续ping测试，并禁用第一个网卡，此时会丢一个包，网络依然正常运行

来自 192.168.30.250 的回复: 字节=32 时间<1ms TTL=64 来自 192.168.30.250 的回复: 字节=32 时间<1ms TTL=64 来自 192.168.30.250 的回复: 字节=32 时间=1ms TTL=64 请求超时。来自 192.168.30.250 的回复: 字节=32 时间=1ms TTL=64 来自 192.168.30.250 的回复: 字节=32 时间<1ms TTL=64

完毕！

以上就是关于gg修改器绑定游戏_gg游戏修改器的全部内容，希望对大家有帮助。